CNC Router

Carbide 3D CNC Router

The Carbide 3D CNC Router has the ability to cut through soft metals, wood, and plastic. It looks a lot like a 3D printer, but instead of printing a figure, it carves one. This machine has the ability to academically benefit not only STEM majors, but students from a variety of disciplines

Specifications

Travel (X): 8in

Travel (Y): 8in

Travel (Z): 3in

Max Speed (X, Y): 100in/min

Max Speed (Z): 50in/min

Mechanical Resolution: .0005in

Mechanical Repeatability: .0015in

Mechanical Accuracy: .005in/ft

Spindle Power: 50watt

Spindle Speed: 2000 - 10000RPM

Max Cutter Diameter: 1/4in

Power Supply: 240 watt

Voltage: 120/240

Weight: 60lbs

Setting Tool Paths

1. Select the part of your design that you want to cut first
2. Create a tool path by choosing either contour or Vcarve
3. Select the tool you are using for each tool path
4. Leave on automatic speed
5. Set max depth to slightly thicker than desired cut depth
6. Set your offset direction as needed
7. Repeat until all sections of drawing are completed
8. Once all tool paths have been set either save the Gcode to a file. If carbide motion is open and printer is connected send to carbide motion

*if using on Mac make sure screen is maximized so that you can see the save to Gcode and send to carbide motion options

Carbide Create

1. Start by choosing the setting icon
2. Then select the Stock Size
   1. Here is were you upload the length and width of the piece of material you are cutting into REMEMBER the length is in inches
3. Next is Stock Thickness, this is how thick the material is
4. The Toolpath Zero is were you're going to set the zero on Carbide Motion (more on this)
5. Then choose the material you are cutting into
6. Make sure the units are in inches
7. Click okay
8. Next create a design
9. Then choose Toolpath
10. Then select V Curve
11. If the tool is correct then click okay
12. If not choose 'edit' and select the correct tool bit size
13. Then choose contour
14. Edit the Max Deph
15. Then choose Offset Direction
    1. This is how the machine will cut into the material
16. Select Okay
17. Then 'Save GCode'
18. Name and save to the desk top
19. Then Open Carbide Motion

Carbide Motion

1. Go to the jog tab and follow the on screen instructions
2. Click the measure tool
3. Using the onscreen interface and arrow keys set zeros by default. Zero is bottom left corner. You should only be able to fit a piece of paper between the machine and the material you are cutting into to
4. Once this is done click set zeroes, then click zero all
5. Finally click on the run tab, and then click begin project