Difference between revisions of "First Time 3D Printing"
From __space Wiki
Line 14: | Line 14: | ||
**Starting with 25% fill should be fine | **Starting with 25% fill should be fine | ||
*Prints take a long time. Generally: 3-10 hours for a small print, 10-17 for a medium, and 17-24 for a large one. Time manage accordingly | *Prints take a long time. Generally: 3-10 hours for a small print, 10-17 for a medium, and 17-24 for a large one. Time manage accordingly | ||
− | *Check out [https://www.tinkercad.com/ Tinkercad]to create a 3D model | + | *Check out [https://www.tinkercad.com/ Tinkercad]to create a 3D model. |
Revision as of 13:54, 27 December 2017
First 3D Print
If this is your first time 3D Printing read over these instructions before getting to work
- The file you want to 3D Print must be an object file (.obj) or an stereolithographic file (.stl)
- Each printer has a slightly different software and set up; see which printers are available, then go to that printer's instructional page on our website
- Think about your print logically:
- It doesn't make sense to print a candy cane standing up right, but it does make sense to print it flat against the bed
- Printing a ring on its side will cause the center to be filled with supports, lying the ring down circumvents this issue, giving you a cleaner print
- Having your design oriented corrected lessens the chance of printing error
- If this is your first print, put "supports" on your design, this will lessen the chance of the print going wrong
- Infill should only fall between 15-40%,
- A higher fill does not equal a better print, but it does equal a high print time
- Starting with 25% fill should be fine
- Prints take a long time. Generally: 3-10 hours for a small print, 10-17 for a medium, and 17-24 for a large one. Time manage accordingly
- Check out Tinkercadto create a 3D model.